P0583 Cruise Control Vacuum Control Circuit Low

P0583 points to a low condition in the cruise control vacuum control circuit. The controller sees voltage, current, or feedback below the expected range.

Code details

Generic OBD-II · P0

System: Speed / Idle
Code type: Generic (SAE / ISO controlled)
Standard: SAE J2012 / ISO 15031-6

Diagnostic boundary

A diagnostic trouble code reports that a monitored test failed. It does not prove one specific part is bad, and manufacturer logic can add vehicle-specific conditions.

Do not replace the cruise servo before confirming the low vacuum-control circuit fault.

Symptoms of P0583

Unstable, high, or low idle, or stalling.
Erratic speedometer, cruise-control, or shift behaviour.
Check-engine light with a hesitation or surge.

Common causes of P0583

A dirty throttle body, idle-control valve, or throttle-position sensor.
A failing vehicle-speed or wheel-speed sensor, or its wiring.
Vacuum leaks or a related sensor forcing the idle/speed strategy.

Useful checks before replacing parts

Check vacuum control command, control voltage, solenoid current, fuse feed, ground or driver control, and freeze-frame cruise conditions.
Inspect for short-to-ground faults, open power feed, failed solenoid windings, connector corrosion, damaged vacuum-control wiring, and weak grounds.
Command the vacuum solenoid and verify both electrical response and actual vacuum routing to the cruise servo.

Related OBD-II codes

These nearby speed / idle entries can help compare wording and pin down the fault area.