P0429 Catalyst Heater Control Circuit Bank 1

P0429 indicates a Catalyst Heater Control Circuit issue on Bank 1. The controller has detected an electrical or command problem in the Bank 1 catalyst heater path.

Code details

Generic OBD-II · P0

System: Emissions
Code type: Generic (SAE / ISO controlled)
Standard: SAE J2012 / ISO 15031-6

Diagnostic boundary

A diagnostic trouble code reports that a monitored test failed. It does not prove one specific part is bad, and manufacturer logic can add vehicle-specific conditions.

Do not replace the heated catalyst until heater power, ground, command, and current draw have been verified.

Symptoms of P0429

Check-engine light, often with no obvious change in how the car drives.
A failed emissions test or incomplete readiness monitors.
Sometimes a faint fuel-vapour smell (on EVAP codes).

Common causes of P0429

A worn catalytic converter or an oxygen/air-fuel sensor reading out of range.
EVAP leaks — a loose or failed gas cap, cracked hose, or purge/vent valve.
Exhaust leaks, fuel-trim problems, or a fault in a related monitor.

Useful checks before replacing parts

Check heater command, fuse feed, relay operation, current draw, ground path, catalyst temperature response, and freeze-frame monitor data.
Inspect heater wiring, connectors near exhaust heat, relay contacts, fuse links, module driver control, and signs of water or heat damage.
Confirm the heater circuit changes state correctly and that catalyst temperature responds when the heater is commanded.

Related OBD-II codes

These nearby emissions entries can help compare wording and pin down the fault area.