P0768 Shift Solenoid D Electrical

P0768 points to an electrical fault in shift solenoid D. The controller detected an open, short, or abnormal response in that circuit.

Code details

Generic OBD-II · P0

System: Transmission
Code type: Generic (SAE / ISO controlled)
Standard: SAE J2012 / ISO 15031-6

Diagnostic boundary

A diagnostic trouble code reports that a monitored test failed. It does not prove one specific part is bad, and manufacturer logic can add vehicle-specific conditions.

Do not replace hydraulic components until the solenoid D circuit is tested electrically.

Symptoms of P0768

Harsh, delayed, or slipping shifts, or being stuck in one gear.
Check-engine light, sometimes with limp-home mode.
Flaring RPM or a shudder under load.

Common causes of P0768

Low or degraded transmission fluid.
A failing speed sensor, shift solenoid, or pressure-control circuit.
Wiring, connector, or internal hydraulic/mechanical faults.

Useful checks before replacing parts

Check solenoid D power feed, control wire, internal harness, case connector, terminal tension, and fluid intrusion.
Measure solenoid circuit resistance or current using service-information limits for the transmission.
Inspect shared power feeds if other shift-solenoid electrical codes are stored at the same time.

Related OBD-II codes

These nearby transmission entries can help compare wording and pin down the fault area.